Vergeboard repair

[Bryan]

Hello,
I was wondering if the conservepoxy products would stabilize my vergeboard? It is 140 years old and is 1 inch pine. There is some rot in it and some warping. Is it possible to apply the products to the vergeboard without taking it down? Any ideas would be greatly appreciated.

Bryan  outdooradventurecanada.com/house

[johnleeke]

Those are some fancy verge boards!

I expect that the wood-epoxy repairs methods can be used with the boards in place, we do it all the time.

If you can post some close up photos showing conditions we can help you further.

John Leeke
www.HistoricHomeWorks.com

[Paul Marlowe]

Bryan,
The CSE epoxies #100 consolidant and #200 patch should work very well on your antique vergeboard.  If access is good it should be able to be restored in place.  You will need to consider whether borates are necessary.  These are generally applied after the wood preparation phase is complete.  This would kill any decay fungus living deep inside the remaining wood.  The wood then needs to be dried below 20% moisture prior to applying the epoxy.

I aggree with John that photos would be helpful as well as a pleasure to see.

Paul